Configuration and management
BAT54-Rail/F..
Release
7.54
06/08
4.9
Named loopback addresses
163
D IP address
IP address of the SYSLOG client.
D Loopback address
Sender address entered into the SYSLOG message. No answer is
expected to a SYSLOG message. The following can be entered as the
loopback address:
D Name of a defined IP network.
D 'INT' for the IP address in the first network with the setting 'Intranet'.
D 'DMZ' for the IP address in the first network with the setting 'DMZ'.
Note: If the list of IP networks or loopback addresses contains an entry
named 'DMZ' then the associated IP address will be used.
D Name of a loopback address.
D Any other IP address.
D Source
D System: System messages (boot events, timer system, etc.)
D Logins: Messages concerning the user's login or logout during the
PPP negotiation, and any errors that occur during this.
D System time: Messages about changes to the system time
D Console logins: Messages about console logins (Telnet, Outband,
etc.), logouts and any errors that occurred during this.
Configuration tool Menu/Table
LANconfig Log & Trace
SYSLOG SYSLOG clients
WEBconfig, Telnet Expert configuration > Setup > SYSLOG > SYSLOG table
To Next Page
Loading...
