LANtools network management
BAT54-Rail/F..
Release
7.54
06/08
5.2
Project management with LANconfig
177
WEBconfig, Telnet or terminal program
Under WEBconfig, Telnet or a terminal program, you will find the settings for
the SNMP read access under the following paths:
5.2.7 Device-specific settings for communications
protocols
With LANconfig, all device actions are conducted using the TFTP protocol.
Since this protocol has disadvantages compared to other protocols when
transmitting large volumes of data, the protocols HTTPS and HTTP can also
be used as alternatives.
The use of the protocols can be set either globally for all devices managed
by a LANconfig or specifically for each individual device. The global settings
overwrite the specific settings here – therefore, in the specific device set-
tings, only the settings allowed in the global configuration can take effect.
Configuration tool Menu/Table
WEBconfig Expert configuration
Setup Config Password-required-for-SNMP-read-access
Terminal/Telnet
Setup/Config/Password-required-for-SNMP-read-access
To Next Page
Loading...
