Diagnosis
226
6.1
Trace information—for advanced users
BAT54-Rail/F..
Release
7.54
06/08
6.1.3 Overview of the parameters
Note: The available traces depend individually on the particular model and
can be listed by entering trace with no arguments on the command line.
This parameter... ... brings up the following display for the trace:
Status status messages for the connection
Error error messages for the connection
IPX-router IPX routing
PPP PPP protocol negotiation
SAP IPX Service Advertising Protocol
IPX-watchdog IPX watchdog spoofing
SPX-watchdog SPX watchdog spoofing
LCR Least-Cost Router
Script script processing
IPX-RIP IPX Routing Information Protocol
Firewall Firewall activities
RIP IP Routing Information Protocol
ARP Address Resolution Protocol
ICMP Internet Control Message Protocol
IP masquerading processes in the masquerading module
DHCP Dynamic Host Configuration Protocol
NetBIOS NetBIOS management
DNS Domain Name Service Protocol
Packet dump display of the first 64 bytes of a package in hexadecimal form
D-channel-dump trace on the D channel of the connected ISDN bus
ATM-cell spoofing at the ATM packet level
ATM-Error ATM errors
ADSL ADSL connections status
SMTP-Client E-mail processing of the integrated mail client
Mail-Client E-mail processing of the integrated mail client
SNTP Simple Network Time Protocol information
NTP Timeserver Trace
Connact Messages from the activity protocol
Cron cron table
RADIUS RADIUS trace
Serial Status of serial interface
USB Status of USB interface
Load-Balancer Load balancing information
VRRP Information concerning Virtual Router Redundancy Protocol
Ethernet Status of ethernet interface