Wireless LAN – WLAN
70
3.4
Configuration of WLAN parameters
BAT54-Rail/F..
Release
7.54
06/08
Access point density
The more access points there are in a given area, the more the reception ar-
eas of the antennae intersect. The setting 'Access point density' can be used
to reduce the reception sensitivity of the antenna.
Maximum distance
Large distances between transmitter and receiver give rise to increasing de-
lays for the data packets. If a certain limit is exceeded, the responses to
transmitted packets no longer arrive within an acceptable time limit. The en-
try for maximum distance increases the wait time for the responses. This dis-
tance is converted into a delay which is acceptable for wireless
communications.
Configuration with WEBconfig or Telnet
Under WEBconfig or Telnet you will find the radio parameters under the fol-
lowing paths:
U Point-to-point connections
Access points are not limited to communications with mobile clients; they can
also transfer data from one access point to another. On the 'Point-to-Point'
tab for the physical interface settings, you can allow the additional exchange
of data with other access points. You can select from:
Configuration tool Menu/Table
WEBconfig Expert configuration
 Setup  Interfaces  WLAN-Interfaces Radio-
Settings
Terminal/Telnet
cd /Setup/Interfaces/WLAN-Interfaces/
Radio settings
To Next Page
Loading...
Need help?
General
