Configuration and management
154
4.8
Managing administrators rights
BAT54-Rail/F..
Release
7.54
06/08
WEBconfig, Telnet or terminal program
Under WEBconfig, Telnet or a terminal program, you will find the settings for
the serial interface under the following paths:
The different user groups are represented by the following values:
The different function rights are represented by the following hexadecimal
values:
The entry results from the sum of the first, second and third columns from the
right. If, for example, the user is to receive rights to use the "Security Wizard",
"Selection of Internet provider", "RAS Wizard", "Change time" and "WLAN
Link Test", then the resulting values are as follows:
D First column from the right: 2 (Security Wizard) + 8 (Selection of Internet
Provider) = "a" (hexadecimal)
D Second column from the right: 1 (RAS Wizard) + 4 (Change Time) = "5"
(hexadecimal)
D Third column from the right: 1 (WLAN-Linktest) = "1" (hexadecimal)
For this example, the function rights are entered with the value "0000015a".
Configuration tool Menu/Table
WEBconfig Expert configuration
 Setup  Config  Admin.-table
Terminal/Telnet
Setup/Config/Admin.-table
Description Rights
Supervisor Supervisor — member of all groups
Admin-RW Local administrator with read and write access
Admin-RO Local administrator with read access but no write access
None No access to the configuration
Value Rights
0x00000001 The user can run the Basic Configuration Wizard
0x00000002 The user can run the Security Wizard
0x00000004 The user can run the Internet Wizard
0x00000008 The user can run the Wizard for selecting Internet providers
0x00000010 The user can run the RAS Wizard
0x00000020 The user can run the LAN-LAN Coupling Wizard
0x00000040 The user can set the date and time (also applies for Telnet and TFTP)
0x00000080 The user can search for additional devices
0x00000100 The user can run the WLAN Link test (also applies for Telnet)
0x00000200 The user can run the a/b Wizard
To Next Page
Loading...
Need help?
General
