Honeywell Experion C300 - Page 124

CEEC300 Function Block
Main Tab
108 Experion C300 Controller User's Guide R301.1
Honeywell 11/06
Plain Text Parameter Name
User
Configurable
Notes
Program Access may
command CEE Run
to Idle
PROGLCKTOIDLE
Yes
Determines whether
program access is
allowed to command
CEE from Run to Idle.
Alarm Info
In-Alarm Flag
INALM
No
Indicates if an alarm
has been detected with
this function block.
Alarming Enabled
ALMENBSTATE
Yes
Allows user to set the
alarm reporting function
used when an alarm
condition is detected by
the function block.
Enable Memory Limit
Exceeded Alarm
ENBMEMALMFL
Yes
Indicates status of
Memory Limit Exceeded
alarm.
Powerup/Resart Settings
CEE State
RRRCEESTATE
Yes
Shows the CEE state
after a RAM retention
restart.
Warm Timeout
WARMTIMEOUT
Yes
Shows the power down
timeout that indicates
whether the CEE block
executes a warm or
cold restart upon power
up.
Batch Events Settings
Batch Events
Memory
BATCHEVTMRY
Yes
Indicates the buffer size
allocated for batch
events.
Time Info
Time Zone
TIMEZONE
Yes
Shows the time zone
offset value for the
controller location