93
View
Interface view
Default level
2: System level
Parameters
interval: IGMP last-member query interval in seconds, in the range of 1 to 5.
Description
Use igmp last-member-query-interval to configure the last-member query interval, the length of time that
the switch waits between sending IGMP group-specific queries on the current interface.
Use undo igmp last-member-query-interval to restore the default.
By default, the IGMP last-member query interval is 1 second.
Related commands: display igmp interface, igmp robust-count, and last-member-query-interval.
Examples
# Set the IGMP last-member query interval to 3 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] igmp last-member-query-interval 3
igmp max-response-time
Syntax
igmp max-response-time interval
undo igmp max-response-time
View
Interface view
Default level
2: System level
Parameters
interval: Maximum response time in seconds for IGMP general queries, in the range of 1 to 25.
Description
Use igmp max-response-time to configure the maximum response time for IGMP general queries on the
current interface.
Use undo igmp max-response-time to restore the default.
By default, the maximum response time for IGMP general queries is 10 seconds.
Related commands: display igmp interface, igmp timer other-querier-present, and max-response-time.
Examples
# Set the maximum response time for IGMP general queries to 8 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
To Next Page
Loading...
Need help?
General