341
To configure a VLAN interface as a static member of an IPv6 multicast group or IPv6 multicast source and
group, execute the mld static-group command on the VLAN interface, and configure the mld-snooping
static-group command on the member ports of the corresponding VLAN.
Related commands: mld-snooping static-group.
Examples
# Configure VLAN-interface 100 to be a statically-connected member of the IPv6 multicast group
FF03::101.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld static-group ff03::101
# Configure VLAN-interface 100 to be a statically connected member of multicast source and group
(2001::101, FF3E::202).
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld static-group ff3e::202 source 2001::101
mld timer other-querier-present
Syntax
mld timer other-querier-present interval
undo mld timer other-querier-present
View
Interface view
Default level
2: System level
Parameters
interval: Specifies an MLD other querier present interval in seconds, in the range of 60 to 300.
Description
Use mld timer other-querier-present to configure the MLD other querier present interval on the current
interface.
Use undo mld timer other-querier-present to restore the default.
By default, MLD other querier present interval = [ MLD query interval ] × [ MLD querier’s robustness
variable ] + [ maximum response delay for MLD general queries ] /2.
Related commands: display mld interface, mld max-response-time, mld robust-count, mld timer query,
and timer other-querier-present.
Examples
# Set the MLD other querier present interval to 200 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface100
[Sysname-Vlan-interface100] mld timer other-querier-present 200
To Next Page
Loading...
Need help?
General