384
View
System view
Default level
2: System level
Parameters
None
Description
Use pim ipv6 to enter IPv6 PIM view.
Use undo pim ipv6 to remove all configurations in IPv6 PIM view.
You must IPv6 multicast routing on the device before this command can take effect.
Related commands: multicast ipv6 routing-enable.
Examples
# Enable IPv6 multicast routing and enter IPv6 PIM view.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] pim ipv6
[Sysname-pim6]
pim ipv6 bfd enable
Syntax
pim ipv6 bfd enable
undo pim ipv6 bfd enable
View
Interface view
Default level
2: System level
Parameters
None
Description
Use pim ipv6 bfd enable to enable IPv6 PIM to work with Bidirectional Forwarding Detection (BFD).
Use undo pim ipv6 bfd enable to disable this feature.
By default, this feature is disabled.
You must enable IPv6 PIM-DM or IPv6 PIM-SM on an interface before you configure this feature on the
interface. Otherwise, this feature is not effective.
Related commands: pim ipv6 dm and pim ipv6 sm.
Examples
# Enable IPv6 multicast routing in the public network, enable IPv6 PIM-SM on interface VLAN-interface
100, and enable IPv6 PIM to work with BFD on the interface.
To Next Page
Loading...
Need help?
General