152
undo pim [ vpn-instance vpn-instance-name ]
View
System view
Default level
2: System level
Parameters
vpn-instance vpn-instance-name: Specifies a VPN, where vpn-instance-name is a case-sensitive string of
1 to 31 characters. If this option is not specified, the command applies to the public network.
Description
Use pim to enter public network PIM view or VPN instance PIM view.
Use undo pim to remove all configurations in public network PIM view or VPN instance PIM view.
IP multicast routing must be enabled in the corresponding instance before this command takes effect.
Related commands: multicast routing-enable.
Examples
# Enable IP multicast routing in the public network and enter public network PIM view.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] pim
[Sysname-pim]
# Enable IP multicast routing in VPN instance mvpn and enter PIM view of VPN instance mvpn.
<Sysname> system-view
[Sysname] ip vpn-instance mvpn
[Sysname-vpn-instance-mvpn] route-distinguisher 100:1
[Sysname-vpn-instance-mvpn] multicast routing-enable
[Sysname-vpn-instance-mvpn] quit
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn]
pim bfd enable
Syntax
pim bfd enable
undo pim bfd enable
View
Interface view
Default level
2: System level
Parameters
None
To Next Page
Loading...
Need help?
General