274
Use undo mld-snooping last-listener-query-interval to restore the default.
By default, the MLD last listener query interval is 1 second.
The MLD last-listener query interval determines the interval for sending MLD multicast-address-specific
queries and the maximum response delay for MLD multicast-address-specific queries in a VLAN.
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
Related commands: last-listener-query-interval and mld-snooping enable.
Examples
# Enable MLD snooping and set the MLD last listener query interval to 3 seconds in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping last-listener-query-interval 3
mld-snooping max-response-time
Syntax
mld-snooping max-response-time interval
undo mld-snooping max-response-time
View
VLAN view
Default level
2: System level
Parameters
interval: Specifies the maximum response delay for MLD general queries in seconds. The value ranges
from 1 to 25.
Description
Use mld-snooping max-response-time to configure the maximum response delay for MLD general
queries in the VLAN.
Use undo mld-snooping max-response-time to restore the default.
By default, the maximum response delay for MLD general queries is 10 seconds.
This command takes effect only if MLD snooping is enabled for the VLAN.
Related commands: max-response-time, mld-snooping enable, and mld-snooping query-interval.
Examples
# Enable MLD snooping and set the maximum response delay for MLD general queries to 5 seconds in
VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
To Next Page
Loading...
Need help?
General