156
Default level
2: System level
Parameters
interval: LAN-delay time in milliseconds, with an effective range of 1 to 32,767.
Description
Use pim hello-option lan-delay to configure the LAN-delay time—namely, the length of time that the
device waits before forwarding a received prune message—on the current interface.
Use undo pim hello-option lan-delay to restore the default.
By default, the LAN-delay time to 500 milliseconds.
Related commands: hello-option lan-delay, hello-option override-interval, and pim hello-option
override-interval.
Examples
# Set the LAN-delay time to 200 milliseconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim hello-option lan-delay 200
pim hello-option neighbor-tracking
Syntax
pim hello-option neighbor-tracking
undo pim hello-option neighbor-tracking
View
Interface view
Default level
2: System level
Parameters
None
Description
Use pim hello-option neighbor-tracking to disable join suppression—namely, enable neighbor
tracking—on the current interface.
Use undo pim hello-option neighbor-tracking to enable join suppression.
By default, join suppression is enabled. Namely, neighbor tracking is disabled.
Related commands: hello-option neighbor-tracking.
Examples
# Disable join suppression on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim hello-option neighbor-tracking
To Next Page
Loading...
