296
all: Specifies all the ports in the current IPv6 multicast VLAN.
Description
Use port to assign the specified ports to the current IPv6 multicast VLAN.
Use undo port to delete the specified ports from the current IPv6 multicast VLAN.
By default, an IPv6 multicast VLAN has no ports.
A port can belong to only one IPv6 multicast VLAN.
You can assign only Ethernet ports, and Layer 2 aggregate interfaces to a multicast VLAN.
Examples
# Assign ports Ethernet 1/0/1 through Ethernet 1/0/5 to IPv6 multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100] port ethernet 1/0/1 to ethernet 1/0/5
port multicast-vlan ipv6
Syntax
port multicast-vlan ipv6 vlan-id
undo port multicast-vlan ipv6
View
Ethernet interface view, Layer 2 aggregate interface view, port group view.
Default level
2: System level
Parameters
vlan-id: Specifies an IPv6 multicast VLAN by its ID, in the range of 1 to 4094.
Description
Use port multicast-vlan ipv6 to assign the current port to the specified IPv6 multicast VLAN.
Use undo port multicast-vlan ipv6 to restore the default.
By default, a port does not belong to any IPv6 multicast VLAN.
A port can belong to only one IPv6 multicast VLAN.
Examples
# Assign Ethernet 1/0/1 to IPv6 multicast VLAN 100.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port multicast-vlan ipv6 100
subvlan (IPv6 multicast VLAN view)
Syntax
subvlan vlan-list
To Next Page
Loading...
Need help?
General