HP 3600 v2 Series User Manual

201
Keywords Function
detail-suppressed
This keyword does not suppress the summary route, but it suppresses
the advertisement of all the more specific routes. To summarize only
some specific routes, use the peer filter-policy command.
suppress-policy
Used to create a summary route and suppress the advertisement of
some summarized routes. To suppress some routes selectively and
leave other routes still advertised, use the if-match clause of the
route-policy command.
origin-policy
Selects only routes that satisfy the routing policy for route
summarization
attribute-policy
Sets attributes except the AS_PATH attribute for the summary route.
You accomplish the same task by using the peer route-policy
command.
Description
Use aggregate to create a summary route in the IPv4 MBGP routing table.
Use undo aggregate to remove a summary route.
By default, no summary route is configured.
Examples
# In IPv4 MBGP address family view, create a summary of 192.213.0.0/16 in the IPv4 MBGP routing
table.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] aggregate 10.40.0.0 255.255.0.0
balance (MBGP address family view)
Syntax
balance number
undo balance
View
IPv4 MBGP address family view
Default level
2: System level
Parameters
number: Specifies the number of MBGP routes for load balancing, in the range of 1 to 8. When it is set
to 1, load balancing is disabled.
Description
Use balance to configure the number of MBGP routes for load balancing.
Use undo balance to restore the default.
By default, no load balancing is configured.

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English