394
Examples
# Set the hello interval to 40 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 timer hello 40
pim ipv6 timer join-prune
Syntax
pim ipv6 timer join-prune interval
undo pim ipv6 timer join-prune
View
Interface view
Default level
2: System level
Parameters
interval: Join/prune interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use pim ipv6 timer join-prune to configure the interval at which join/prune messages are sent on the
current interface.
Use undo pim ipv6 timer join-prune to restore the default.
By default, the join/prune interval is 60 seconds.
Related commands: timer join-prune.
Examples
# Set the join/prune interval to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 timer join-prune 80
pim ipv6 triggered-hello-delay
Syntax
pim ipv6 triggered-hello-delay interval
undo pim ipv6 triggered-hello-delay
View
Interface view
Default level
2: System level
Parameters
interval: Maximum delay in seconds between hello messages, with an effective range of 1 to 60.
To Next Page
Loading...
Need help?
General