161
By default, the state refresh feature is enabled.
Related commands: state-refresh-interval, state-refresh-rate-limit, and state-refresh-ttl.
Examples
# Disable state refresh on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo pim state-refresh-capable
pim timer graft-retry
Syntax
pim timer graft-retry interval
undo pim timer graft-retry
View
Interface view
Default level
2: System level
Parameters
interval: Graft retry period in seconds, with an effective range of 1 to 65,535.
Description
Use pim timer graft-retry to configure the graft retry period.
Use undo pim timer graft-retry to restore the default.
By default, the graft retry period is 3 seconds.
Examples
# Set the graft retry period to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer graft-retry 80
pim timer hello
Syntax
pim timer hello interval
undo pim timer hello
View
Interface view
Default level
2: System level
To Next Page
Loading...
Need help?
General