356
By default, the BS period value is determined by this formula: BS period = (BS timeout – 10) / 2.
The default BS timeout is 130 seconds, so the default BS period is (130 – 10) / 2 = 60 (seconds).
Related commands: c-bsr and c-bsr holdtime.
Examples
# Set the BS period to 30 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] c-bsr interval 30
c-bsr priority (IPv6 PIM view)
Syntax
c-bsr priority priority
undo c-bsr priority
View
IPv6 PIM view
Default level
2: System level
Parameters
priority: Priority of the C-BSR, in the range of 0 to 255. A larger value means a higher priority.
Description
Use c-bsr priority to configure the global C-BSR priority.
Use undo c-bsr priority to restore the default.
By default, the C-BSR priority is 64.
Related commands: c-bsr.
Examples
# Set the global C-BSR priority to 5.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] c-bsr priority 5
c-bsr scope
Syntax
c-bsr scope { scope-id | admin-local | global | organization-local | site-local } [ hash-length
hash-length | priority priority ] *
undo c-bsr scope { scope-id | admin-local | global | organization-local | site-local }
View
IPv6 PIM view
To Next Page
Loading...
Need help?
General