377
dscp (IPv6 PIM view)
Syntax
dscp dscp-value
undo dscp
View
IPv6 PIM view
Default level
2: System level
Parameters
dscp-value: Specifies the DSCP value for IPv6 PIM messages, in the range of 0 to 63.
Description
Use dscp to set the DSCP value for IPv6 PIM messages.
Use undo dscp to restore the default.
The default DSCP value in IPv6 PIM messages is 48.
Examples
# Set the DSCP value to 63 for IPv6 PIM messages.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] dscp 63
embedded-rp
Syntax
embedded-rp [ acl6-number ]
undo embedded-rp [ acl6-number ]
View
IPv6 PIM view
Default level
2: System level
Parameters
acl6-number: Basic IPv6 ACL number, in the range of 2000 to 2999.
Description
Use embedded-rp to enable embedded RP.
Use undo embedded-rp to disable embedded RP or restore the default.
By default, embedded RP is enabled for IPv6 multicast groups in the default embedded RP address
scopes.
The default embedded RP address scopes are FF7x::/12 and FFFx::/12, where x represents any legal
address scope. For more information about the scope field, see Multicast overview.
To Next Page
Loading...
Need help?
General