265
Description
Use mld-snooping done source-ip to configure the source IPv6 address of the MLD done messages that
the MLD snooping proxy sends.
Use undo mld-snooping done source-ip to restore the default.
By default, the source IPv6 address of the MLD done messages that the MLD snooping proxy sends is
FE80::02FF:FFFF:FE00:0001.
Before you configure this command in a VLAN, enable MLD snooping for the VLAN.
The source IPv6 address configured in the mld-snooping done source-ip command also applies when
the simulated host sends MLD done messages.
Related commands: mld-snooping enable.
Examples
# Enable MLD snooping in VLAN 2 and configure the source IPv6 address of MLD done messages that
the MLD snooping proxy sends in VLAN 2 to FE80:0:0:1::1.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping done source-ip fe80:0:0:1::1
mld-snooping dot1p-priority
Syntax
mld-snooping dot1p-priority priority-number
undo mld-snooping dot1p-priority
View
VLAN view
Default level
2: System level
Parameters
priority-number: Specifies an 802.1p precedence for MLD messages, in the range of 0 to 7. A higher
number indicates a higher precedence.
Description
Use mld-snooping dot1p-priority to set the 802.1p precedence for the MLD messages in a VLAN.
Use undo mld-snooping dot1p-priority to restore the default.
The default 802.1p precedence for the MLD messages in a VLAN is 0.
Before you configure this command in a VLAN, enable MLD snooping for the VLAN.
Related commands: mld-snooping enable.
To Next Page
Loading...
Need help?
General