443
Default level
2: System level
Parameters
ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters. You
must create the IPv6 MBGP peer group in IPv6 MBGP view before you can activate it here.
ipv6-address: Specifies an IPv6 MBGP peer by its IP address.
Description
Use peer enable to enable an IPv6 MBGP peer or peer group.
Use undo peer enable to disable an IPv6 MBGP peer or peer group.
By default, no IPv6 MBGP peer or peer group is enabled.
If an IPv6 MBGP peer or peer group is disabled, the router does not exchange routing information with
it.
Examples
# Enable IPv6 MBGP peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 as-number 100
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer 1:2::3:4 enable
peer filter-policy (IPv6 MBGP address family view)
Syntax
peer { ipv6-group-name | ipv6-address } filter-policy acl6-number { import | export }
undo peer { ipv6-group-name | ipv6-address } filter-policy [ acl6-number ] { import | export }
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters.
ipv6-address: Specifies an IPv6 MBGP peer by its IP address.
acl6-number: Specifies an IPv6 ACL number, in the range of 2000 to 3999.
import: Applies the filter to routes received from the IPv6 MBGP peer or the peer group.
export: Applies the filter to routes advertised to the IPv6 MBGP peer or the peer group.
Description
Use peer filter-policy to configure an IPv6 ACL-based filter policy for an IPv6 MBGP peer or peer group.
To Next Page
Loading...
Need help?
General