404
Description
Use static-rp to configure a static RP.
Use undo static-rp to configure a static RP.
By default, no static RP is configured.
IPv6 PIM-SM or IPv6 PIM-DM cannot be enabled on an interface that acts as a static RP.
When the IPv6 ACL rule applied on a static RP changes, a new RP must be elected for all IPv6 multicast
groups.
You can configure multiple static RPs by using this command repeatedly. However, if you use this
command multiple times and specify the same static RP address or reference the same IPv6 ACL rule, the
last configuration overrides the previous one. If you have configured multiple static RPs for the same IPv6
multicast group, the one with the highest IPv6 address provides services for the group.
You can configure up to 50 static RPs on the same device.
Related commands: display pim ipv6 rp-info.
Examples
# Configure the interface with an IPv6 address of 2001::2 as a static RP to provide services for the IPv6
multicast groups in the address range of FF03::101/64 defined in IPv6 ACL 2001, and give priority to
this static RP in the case of static/dynamic RP conflict.
<Sysname> system-view
[Sysname] acl ipv6 number 2001
[Sysname-acl6-basic-2001] rule permit source ff03::101 64
[Sysname-acl6-basic-2001] quit
[Sysname] pim ipv6
[Sysname-pim6] static-rp 2001::2 2001 preferred
timer hello (IPv6 PIM view)
Syntax
timer hello interval
undo timer hello
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: Hello interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use timer hello to configure the hello interval globally.
Use undo timer hello to restore the default.
By default, hello messages are sent at the interval of 30 seconds.
Related commands: pim ipv6 timer hello.
To Next Page
Loading...
Need help?
General