HP 3600 v2 Series User Manual

113
PIM configuration commands (available only
on the HP 3600 v2 EI)
The term "router" in this document refers to both routers and Layer 3 switches.
The term "interface" in this chapter collectively refers to Layer 3 interfaces, including VLAN and Layer 3
Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by using the port link-mode route
command (see Layer 2—LAN Switching Configuration Guide).
auto-rp enable
Syntax
auto-rp enable
undo auto-rp enable
View
Public network PIM view, VPN instance PIM view
Default level
2: System level
Parameters
None
Description
Use auto-rp enable to enable auto-RP.
Use undo auto-rp enable to disable auto-RP.
By default, auto-RP is disabled.
Related commands: static-rp.
Examples
# Enable auto-RP in the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] auto-rp enable
# Enable auto-RP in VPN instance mvpn.
<Sysname> system-view
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] auto-rp enable

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English