HP 3600 v2 Series User Manual

269
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping general-query source-ip fe80:0:0:1::1
mld-snooping group-limit
Syntax
mld-snooping group-limit limit [ vlan vlan-list ]
undo mld-snooping group-limit [ vlan vlan-list ]
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
Parameters
limit: Specifies the maximum number of IPv6 multicast groups that a port can join. For the HP 3600 v2
EI switches, the value ranges from 0 to 1000. For the HP 3600 v2 SI switches, the value ranges from 0
to 512.
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The value range of a VLAN
ID is 1 to 4094.
Description
Use mld-snooping group-limit to configure the maximum number of IPv6 multicast groups that a port can
join.
Use undo mld-snooping group-limit to restore the default.
By default, the upper limit is 1000 for the HP 3600 v2 EI switches, and 512 for the HP 3600 v2 SI
switches.
For the HP 3600 v2 EI switches, you can also use the mld group-limit command to limit the number of
IPv6 multicast groups that an interface can join. However, if you configure the limit both in a VLAN and
on a VLAN interface of this VLAN by using these two commands, inconsistencies might exist between
Layer 2 and Layer 3 table entries. Therefore, HP recommends you to configure the limit only on the VLAN
interface.
If you do not specify any VLAN when using this command in Layer 2 Ethernet interface view or Layer 2
aggregate interface view, the command takes effect for all VLANs that the interface belongs to. If you
specify one or multiple VLANs, the command takes effect for the specified VLANs that the interface
belongs to.
If you do not specify any VLAN when using this command in port group view, the command takes effect
on all the ports in this group. If you specify one or multiple VLANs, the command takes effect only on
those ports in this group that belong to the specified VLANs.
Related commands: mld group-limit.

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English