To Next Page

To Previous Page

449

peer reflect-client (IPv6 MBGP address family view)

Syntax

peer { ipv6-group-name | ipv6-address } reflect-client

undo peer { ipv6-group-name | ipv6-address } reflect-client

View

IPv6 MBGP address family view

Default level

2: System level

Parameters

ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters.

ipv6-address: Specifies an IPv6 MBGP peer by its IP address.

Description

Use peer reflect-client to configure the router as a route reflector and specify an IPv6 MBGP peer or a

peer group as its client.

Use undo peer reflect-client to remove the configuration.

By default, neither route reflector nor client is configured.

Related commands: reflect between-clients and reflector cluster-id.

Examples

# Configure the local device as a route reflector and specify the peer group test as a client.

<Sysname> system-view

[Sysname] bgp 100

[Sysname-bgp] ipv6-family

[Sysname-bgp-af-ipv6] group test internal

[Sysname-bgp-af-ipv6] quit

[Sysname-bgp] ipv6-family multicast

[Sysname-bgp-af-ipv6-mul] peer test enable

[Sysname-bgp-af-ipv6-mul] peer test reflect-client

peer route-limit (IPv6 MBGP address family view)

Syntax

peer { ipv6-group-name | ipv6-address } route-limit limit [ percentage ]

undo peer { ipv6-group-name | ipv6-address } route-limit