HP 3600 v2 Series

259
[Sysname-mld-snooping] entry-limit 512
fast-leave (MLD-snooping view)
Syntax
fast-leave [ vlan vlan-list ]
undo fast-leave [ vlan vlan-list ]
View
MLD-snooping view
Default level
2: System level
Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The value range of a VLAN
ID is 1 to 4094. If you do not specify any VLAN, the command applies to all VLANs. If you specify one
or multiple VLANs, the command applies to the specified VLANs only.
Description
Use fast-leave to enable fast-leave processing globally. With this function enabled, when the switch
receives an MLD done message on a port, it directly removes that port from the forwarding table entry for
the specific group.
Use undo fast-leave to disable fast-leave processing globally.
By default, fast-leave processing is disabled.
For the HP 3600 v2 EI switches, this command takes effect in both MLD snooping-enabled VLANs and
VLANs with MLD enabled on their VLAN interfaces.
For the HP 3600 v2 SI switches, this command takes effect in MLD snooping-enabled VLANs.
Related commands: mld-snooping fast-leave.
Examples
# Enable fast-leave processing globally in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] fast-leave vlan 2
group-policy (MLD-snooping view)
Syntax
group-policy acl6-number [ vlan vlan-list ]
undo group-policy [ vlan vlan-list ]
View
MLD-snooping view