154
pim dm
Syntax
pim dm
undo pim dm
View
Interface view
Default level
2: System level
Parameters
None
Description
Use pim dm to enable PIM-DM.
Use undo pim dm to disable PIM-DM.
By default, PIM-DM is disabled.
This command takes effect only after IP multicast routing is enabled in the corresponding instance.
PIM-DM cannot be used for multicast groups in the SSM group range.
Related commands: multicast routing-enable, pim sm, and ssm-policy.
Examples
# Enable IP multicast routing in the public network, and enable PIM-DM on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim dm
pim hello-option dr-priority
Syntax
pim hello-option dr-priority priority
undo pim hello-option dr-priority
View
Interface view
Default level
2: System level
Parameters
priority: Router priority for DR election, in the range of 0 to 4294967295. A larger value of this argument
means a higher priority.
Description
Use pim hello-option dr-priority to configure the router priority for DR election on the current interface.
To Next Page
Loading...
Need help?
General