392
Default level
2: System level
Parameters
None
Description
Use pim ipv6 sm to enable IPv6 PIM-SM.
Use undo pim ipv6 sm to disable IPv6 PIM-SM.
By default, IPv6 PIM-SM is disabled.
This command can take effect only after IPv6 multicast routing is enabled on the device.
Related commands: multicast ipv6 routing-enable and pim ipv6 dm.
Examples
# Enable IPv6 multicast routing, and enable IPv6 PIM-SM on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 sm
pim ipv6 state-refresh-capable
Syntax
pim ipv6 state-refresh-capable
undo pim ipv6 state-refresh-capable
View
Interface view
Default level
2: System level
Parameters
None
Description
Use pim ipv6 state-refresh-capable to enable the state refresh feature on the interface.
Use undo pim ipv6 state-refresh-capable to disable the state refresh feature.
By default, the state refresh feature is enabled.
Related commands: state-refresh-hoplimit, state-refresh-interval, and state-refresh-rate-limit.
Examples
# Disable state refresh on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo pim ipv6 state-refresh-capable
To Next Page
Loading...
Need help?
General