386
Description
Use pim ipv6 dm to enable IPv6 PIM-DM.
Use undo pim ipv6 dm to disable IPv6 PIM-DM.
By default, IPv6 PIM-DM is disabled.
This command can take effect only after IPv6 multicast routing is enabled on the device.
IPv6 PIM-DM cannot be used for IPv6 multicast groups in the IPv6 SSM group range.
Related commands: multicast ipv6 routing-enable, pim ipv6 sm, and ssm-policy.
Examples
# Enable IPv6 multicast routing, and enable IPv6 PIM-DM on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 dm
pim ipv6 hello-option dr-priority
Syntax
pim ipv6 hello-option dr-priority priority
undo pim ipv6 hello-option dr-priority
View
Interface view
Default level
2: System level
Parameters
priority: Router priority for DR election, in the range of 0 to 4294967295. A larger value means a higher
priority.
Description
Use pim ipv6 hello-option dr-priority to configure the router priority for DR election on the current
interface.
Use undo pim ipv6 hello-option dr-priority to restore the default.
By default, the router priority for DR election is 1.
Related commands: hello-option dr-priority.
Examples
# Set the router priority for DR election to 3 on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 hello-option dr-priority 3
To Next Page
Loading...
Need help?
General