HP 3600 v2 Series

281
mld-snooping special-query source-ip
Syntax
mld-snooping special-query source-ip { ipv6-address | current-interface }
undo mld-snooping special-query source-ip
View
VLAN view
Default level
2: System level
Parameters
ipv6-address: Specifies an IPv6 link-local address as the source IPv6 address of MLD
multicast-address-specific queries.
current-interface: Specifies the source IPv6 link-local address of the VLAN interface of the current VLAN
as the source IPv6 address of MLD multicast-address-specific queries. If the current VLAN interface does
not have an IPv6 address, the default IPv6 address FE80::02FF:FFFF:FE00:0001 is used as the source
IPv6 address of MLD multicast-address-specific queries.
Description
Use mld-snooping special-query source-ip to configure the source IPv6 address of MLD
multicast-address-specific queries.
Use undo mld-snooping special-query source-ip to restore the default.
By default, the source IPv6 address of MLD multicast-address-specific queries is
FE80::02FF:FFFF:FE00:0001.
This command takes effect only if MLD snooping is enabled for the VLAN.
Related commands: mld-snooping enable.
Examples
# In VLAN 2, enable MLD snooping and specify FE80:0:0:1::1 as the source IPv6 address of MLD
multicast-address-specific queries.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping special-query source-ip fe80:0:0:1::1
mld-snooping static-group
Syntax
mld-snooping static-group ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
undo mld-snooping static-group ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view