HP 3600 v2 Series User Manual

49
Multicast routing and forwarding configuration
commands (available only on the HP 3600 v2
EI)
The term "router" in this document refers to both routers and Layer 3 switches.
The term "interface" in the multicast routing and forwarding features collectively refers to Layer 3
interfaces, including VLAN interfaces and Layer 3 Ethernet interfaces. You can set an Ethernet port as a
Layer 3 interface by using the port link-mode route command (see Layer 2—LAN Switching
Configuration Guide).
delete ip rpf-route-static
Syntax
delete ip rpf-route-static [ vpn-instance vpn-instance-name ]
View
System view
Default level
2: System level
Parameters
vpn-instance vpn-instance-name: Specifies a VPN by its name, a case-sensitive string of 1 to 31
characters. If this option is not specified, the command deletes all multicast static routes on the public
network.
Description
Use delete ip rpf-route-static to delete all multicast static routes.
Related commands: ip rpf-route-static.
Examples
# Delete all multicast static routes on the public network.
<Sysname> system-view
[Sysname] delete ip rpf-route-static
This will erase all multicast static routes and their configurations, you must reconfigure
all static routes
Are you sure?[Y/N]:

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English