442
peer default-route-advertise (IPv6 MBGP address family view)
Syntax
peer { ipv6-group-name | ipv6-address } default-route-advertise [ route-policy route-policy-name ]
undo peer { ipv6-group-name | ipv6-address } default-route-advertise
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters.
ipv6-address: Specifies an IPv6 MBGP peer by its IP address.
route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63 characters.
Description
Use peer default-route-advertise to advertise a default route to an IPv6 MBGP peer or a peer group.
Use undo peer default-route-advertise to disable default route advertisement to an IPv6 MBGP peer or
a peer group.
By default, no default route is advertised to any IPv6 MBGP peer or peer group.
When you use this command used, the router unconditionally sends a default route with the next hop as
itself to the IPv6 MBGP peer or peer group, regardless of whether the default route is available in the
routing table.
Examples
# Advertise a default route to the IPv6 MBGP peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 as-number 100
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer 1:2::3:4 enable
[Sysname-bgp-af-ipv6-mul] peer 1:2::3:4 default-route-advertise
peer enable (IPv6 MBGP address family view)
Syntax
peer { ipv6-group-name | ipv6-address } enable
undo peer { ipv6-group-name | ipv6-address } enable
View
IPv6 MBGP address family view
To Next Page
Loading...
Need help?
General