150
Description
Use holdtime join-prune to configure the global value of the join/prune timeout time.
Use undo holdtime join-prune to restore the default.
By default, the join/prune timeout time is 210 seconds.
Related commands: holdtime assert, pim holdtime assert, and pim holdtime join-prune.
Examples
# Set the global value of the join/prune timeout time to 280 seconds in the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] holdtime join-prune 280
# Set the global value of the join/prune timeout time to 280 seconds in VPN instance mvpn.
<Sysname> system-view
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] holdtime join-prune 280
jp-pkt-size (PIM view)
Syntax
jp-pkt-size packet-size
undo jp-pkt-size
View
Public network PIM view, VPN instance PIM view
Default level
2: System level
Parameters
packet-size: Maximum size of each join/prune message in bytes, in the range of 100 to 8100.
Description
Use jp-pkt-size to configure the maximum size of each join/prune message.
Use undo jp-pkt-size to restore the default.
By default, the maximum size of each join/prune message is 8100 bytes.
If PIM snooping-enabled switches are deployed in the PIM network, be sure to set a value no greater than
the path MTU for the maximum size of each join/prune message on the receiver-side edge PIM devices
Related commands: jp-queue-size.
Examples
# Set the maximum size of each join/prune message to 1500 bytes in the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] jp-pkt-size 1500
# Set the maximum size of each join/prune message to 1500 bytes in VPN instance mvpn.
<Sysname> system-view
To Next Page
Loading...
Need help?
General