94
[Sysname-Vlan-interface100] igmp max-response-time 8
igmp proxying enable
Syntax
igmp proxying enable
undo igmp proxying enable
View
Interface view
Default level
2: System level
Parameters
None
Description
Use igmp proxying enable to enable IGMP proxying on an interface.
Use undo igmp proxying enable to disable IGMP proxying on the interface.
By default, IGMP proxying is disabled.
This command takes effect only after IP multicast routing is enabled on the corresponding instance.
If IGMP proxying is enabled on a loopback interface, the proxy switch maintains only the IGMP routing
table without adding the IGMP routes to the multicast routing table and forwarding table.
Related commands: multicast routing-enable.
Examples
# Enable IP multicast routing on the public network and enable IGMP proxying on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] igmp proxying enable
igmp proxying forwarding
Syntax
igmp proxying forwarding
undo igmp proxying forwarding
View
Interface view
Default level
2: System level
Parameters
None
To Next Page
Loading...
