249
reflector cluster-id (MBGP address family view)
Syntax
reflector cluster-id { cluster-id | ip-address }
undo reflector cluster-id
View
IPv4 MBGP address family view
Default level
2: System level
Parameters
cluster-id: Specifies a route reflector by its cluster ID, in the range of 1 to 4294967295.
ip-address: Specifies a route reflector by its IP address, in the format of an IP address.
Description
Use reflector cluster-id to configure the cluster ID of the route reflector.
Use undo reflector cluster-id to remove the configured cluster ID.
By default, each route reflector uses its router ID as the cluster ID.
A route reflector reflects a route from a client to another client. The router ID of the route reflector is the ID
of the cluster. You can configure multiple route reflectors to improve network stability. If a cluster has
multiple route reflectors, you must use the reflector cluster-id command to specify the same cluster ID for
these route reflectors, in order to avoid routing loops.
Related commands: reflect between-clients and peer reflect-client.
Examples
# Specify 80 as the cluster ID for the route reflector, which is one of multiple route reflectors in the cluster.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] reflector cluster-id 80
refresh bgp ipv4 multicast
Syntax
refresh bgp ipv4 multicast { all | ip-address | group group-name | external | internal } { export |
import }
View
User view
Default level
2: Monitor level
Parameters
all: Soft-resets all BGP connections.
To Next Page
Loading...
Need help?
General