HP 3600 v2 Series User Manual

351
IPv6 PIM configuration commands (available
only on the HP 3600 v2 EI)
The term "router" in this document refers to both routers and Layer 3 switches.
The term "interface" in this chapter collectively refers to Layer 3 interfaces, including VLAN and Layer 3
Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by using the port link-mode route
command (see Layer 2—LAN Switching Configuration Guide).
bidir-pim enable (IPv6 PIM view)
Syntax
bidir-pim enable
undo bidir-pim enable
View
IPv6 PIM view
Default level
2: System level
Parameters
None
Description
Use bidir-pim enable to enable IPv6 BIDIR-PIM.
Use undo bidir-pim enable to disable IPv6 BIDIR-PIM.
By default, IPv6 BIDIR-PIM is disabled.
This command is effective only after IPv6 multicast routing is enabled.
Related commands: multicast ipv6 routing-enable and pim ipv6.
Examples
# Enable IPv6 multicast routing, enter IPv6 PIM view, and enable IPv6 BIDIR-PIM.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] pim ipv6
[Sysname-pim6] bidir-pim enable
bsm-fragment enable (IPv6 PIM view)
Syntax
bsm-fragment enable
undo bsm-fragment enable

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English