330
This command can take effect only after IPv6 multicast routing is enabled on the device.
Related commands: mld enable and multicast ipv6 routing-enable.
Examples
# Enable IPv6 multicast routing and enter MLD view.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] mld
[Sysname-mld]
mld enable
Syntax
mld enable
undo mld enable
View
Interface view
Default level
2: System level
Parameters
None
Description
Use mld enable to enable MLD on the current interface.
Use undo mld enable to disable MLD on the current interface.
By default, MLD is disabled on the current interface.
This command can take effect only after IPv6 multicast routing is enabled on the device.
Other MLD configurations performed on the interface can take effect only after MLD is enabled on the
interface.
Related commands: mld and multicast ipv6 routing-enable.
Examples
# Enable IPv6 multicast routing and enable MLD on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld enable
mld fast-leave
Syntax
mld fast-leave [ group-policy acl6-number ]
undo mld fast-leave
To Next Page
Loading...
