390
pim ipv6 holdtime join-prune
Syntax
pim ipv6 holdtime join-prune interval
undo pim ipv6 holdtime join-prune
View
Interface view
Default level
2: System level
Parameters
interval: Join/prune timeout time in seconds, with an effective range of 1 to 65,535.
Description
Use pim ipv6 holdtime join-prune to configure the join/prune timeout time on the interface.
Use undo pim ipv6 holdtime join-prune to restore the default.
By default, the join/prune timeout time is 210 seconds.
Related commands: holdtime assert, holdtime join-prune, and pim ipv6 holdtime assert.
Examples
# Set the join/prune timeout time to 280 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 holdtime join-prune 280
pim ipv6 neighbor-policy
Syntax
pim ipv6 neighbor-policy acl6-number
undo pim ipv6 neighbor-policy
View
Interface view
Default level
2: System level
Parameters
acl6-number: Basic IPv6 ACL number, in the range of 2000 to 2999. When the IPv6 ACL is defined, the
source keyword in the rule command specifies a legal source address range for hello messages.
Description
Use pim ipv6 neighbor-policy to configure a legal source address range for hello messages to guard
against hello message spoofing.
Use undo pim ipv6 neighbor-policy to restore the default.
To Next Page
Loading...
Need help?
General