142
Table 36 Command output
Field Descri
tion
VPN-Instance: public net
Public network.
Total 0 (*, G) entry; 1 (S, G) entry Number of (S,G) and (*, G) entries in the PIM routing table.
(172.168.0.2, 227.0.0.1)
(S, G) entry in the PIM routing table.
RP IP address of the RP.
Protocol
PIM mode.
Flag
Flag of the (S, G) or (*, G) entry in the PIM routing table:
• 2MSDP—The entry is contained in the next SA message to notify an
MSDP peer.
• ACT—The entry has been used for routing data.
• BIDIR—The entry was created by BIDIR-PIM.
• DEL—The entry will be removed.
• EXPRUNE—Some outgoing interfaces are pruned by other multicast
routing protocols.
• EXT—The entry contains outgoing interfaces provided by other
multicast routing protocols.
• LOC—The entry is on a router directly connected to the same subnet
with the multicast source.
• MSDP—The entry is learnt from MSDP SA messages.
• NIIF—The entry contains unknown incoming interfaces.
• NONBR—The entry has a PIM neighbor searching failure.
• RPT—The entry is on a RPT branch where (S, G) prunes have been
sent to the RP.
• RQ—The entry is on the receiving side of the switch-MDT switchover.
• SPT—The entry is on the SPT.
• SQ—The entry is on the originator side of switch-MDT switchover.
• SWT—The entry is in the process of RPT-to-SPT switchover.
• WC—The entry is a wildcard routing entry.
Uptime Length of time for which the (S, G) or (*, G) entry has existed.
Upstream interface
Upstream (incoming) interface of the (S, G) or (*, G) entry. If the
upstream interface is an interface of another VPN, the VPN name is
displayed.
Upstream neighbor Upstream neighbor of the (S, G) or (*, G) entry.
RPF prime neighbor
RPF neighbor of the (S, G) or (*, G) entry:
• For a (*, G) entry, if this router is the RP, the RPF neighbor of this (*, G)
entry is NULL.
• For an (S, G) entry, if this router directly connects to the multicast
source, the RPF neighbor of this (S, G) entry is NULL.
To Next Page
Loading...
