I
-
I
-
Using Instrument Functions
Saving and Recalling Measurement Results
Saving
Instrument
Data
When you save data to a
IYe,
the analyzer automatically selects a
file
name
for you. Since these names may not be as descriptive as desirable, you may
change the name of the
fle
after it has been saved, or you can save it to a file
name of your choice by using the
It9-!3&
S%GO
function. See “Other File
Utilities” later in this chapter for information on how to change a
hle
name.
When saving a file using the Its-Save
Sta%e
function, enter the Ele name
in one of the following ways:
l
Use an external keyboard connected to the analyzer’s rear panel DIN
KEYBOARD connector and type in the
hlename.
(For information on using
a keyboard, see “Using a Keyboard” later in this chapter.)
l Use the front panel knob and
Safect
Ghmacter
key to point and select
each character of the new hlename. Then press
EMXW
.
NOTE
Refer to Chapter 12 at the end of this guide for information on the analyzer’s instrument state
memory allocation.
4-67
I-
To Next Page
Loading...
