HP 8712C - Using the BEGIN Key to Make Measurements

I
-
Using the BEGIN Key to Make Measurements
BEGIN
I I
NETWORK ANALYZER
W~lOb
Figure 3-4. The (EiZiK) Key
The @EEi@ key allows you to quickly and easily configure the analyzer (from
the @Zi?ZF] condition) to measure the following devices:
0 ampliGers
0 filters
l broadband passive devices
0 mixers
l cables (Option 100 only)
Conf@uring basic measurements from the (El key helps you ensure
correct instrument set up. The analyzer guides you through the initial steps
and conf@res itself for the device type you select.
3-12
I-