EasyManua.ls Logo

HP 8712C - User-Defined TTL InputOutput

HP 8712C
559 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Automating Measurements
Operator Interaction
User-Defined
TTL
Input/Output
The USER TTL port can be used as a general-purpose input or output. Like
the LIMIT TEST IN/OUT line, the USER TTL IN/OUT line is au open collector
drive. When used as an input, the state of the USER TTL IN/OUT line can be
read with either the SCPI command
“DIAG:PORT:READ?
15,l”
or with the
IBASIC
command
I =
READIO(lS,l>
When used as an output, the state of the USER TTL
IN/OUT
line can be set
with either the SCPI command
“DIAG:PORT:WRITE
15,1
,value”
or with the
IBASIC
command
WRITE10
15,1;value
The USER TTL IN/OUT port can also be used in conjunction with an external
switch for
softkey
auto-stepping, or as a “sweep out” port. Be sure that USER
TTL IN/OUT port is
coniigured
properly for general-purpose I/O by pressing
[SYSTEM OPTIONS)
&w%rxa
Caxrfig
Umr
TTL
Gatiig
‘D#fauI%
. Or use
the following SCPI command:
SYST:COMM:TTL:USER:FEED
DEFAULT
CAUTION
Be sure to observe static precautions when using this port.
7-34

Table of Contents

Related product manuals