HP 8712C User Manual

I
-
Step 3. Check the Analyzer Operation
1. Turn on the line switch of the analyzer. After approximately 30 seconds, a
display box should appear on the screen with the following information:
l The model number of your analyzer (either HP 8712C or HP 8714C)
l The firmware revision
l The serial number of your analyzer
l Installed options
2. Verify that the serial number and options displayed on the screen match
the information on the rear panel serial label.
3. The operator’s check should be performed on the analyzer to provide a
high degree of confidence that the analyzer is working properly. Refer to
Chapter 2 for instructions on how to perform the operator’s check.
l-9
I-

HP 8712C Specifications

General

Brand	HP
Model	8712C
Category	Measuring Instruments
Language	English