Front/Rear Panel
Connectors
RF
Connectors
REFLECTION
RF
OUT
The standard front panel RF OUT connector is a female type-N 50 0
connector. When Option
1EC
is ordered, this front panel connector is a
female type-N 75
D
connector.
This port outputs the RF signal and also serves as an input for reflection
measurements.
TRANSMISSION
RF IN
The standard front panel RF IN connector is a female type-N 50
R
connector.
When Option
1EC
is ordered, this front panel connector is a female
type-N 75
n
connector.
This port receives the RF signal for internal transmission measurements.
CAUTION
While 50
D
and 75 0 Type-N connectors are similar in appearance, they are
not
compatible. 75
n
type-N connectors have a smaller center pin. Connector
damage can result if you attach a 50
61
male connector to a 75
61
female
connector.
‘lb adapt from 50
61
to 75
fl),
always use a minimum loss pad:
l
For adapting from 50
fl
female to 75
fl
female use an HP
11852B,
Option 004, minimum loss pad.
l
For adapting from 75
R
female to 50
fl
female, use a standard HP
11852B
minimum loss pad.
8-13
To Next Page
Loading...
