HP 8712C User Manual

I
-
I
-
Making Measurements
Making a Power Measurement using Broadband Detection
Enter the Measurement Parameters
Press the following keys on the analyzer:
c-1
(jMEAs-
POW%@
NOTE
This example measurement uses the default instrument parameters for a power measurement. If your
particular power measurement requires specific parameters (such as frequency range, source power
level, number of data points, and sweep time1 enter them now
3-31
CAUTION
Damage to your analyzer will occur if the receiver input power exceeds
+23 dBm or 25 Vdc. The analyzer’s source cannot signilicantly exceed this
level, however if your DUT has gain, then attenuation on the RF IN port
may be necessary. See “When to Use Attenuation and Amplilication in a
Measurement Setup” earlier in this chapter for more information.

HP 8712C Specifications

General

Brand	HP
Model	8712C
Category	Measuring Instruments
Language	English