EasyManua.ls Logo

HP 8712C - AUTOST Files

HP 8712C
559 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Automating Measurements
Automated Measurement Setup and Control
AUTOST
files
When
IBASIC
is used, the measurement control program can be saved as an
AUTOST file on the analyzer’s non-volatile RAM disk. When the analyzer’s
power is turned on, it will first check for this file on the non-volatile RAM
disk and then on the 3.5” disk, and if found, load it and run it. This feature
simplifies the task of turning on an automated test station at the beginning of
a working day, or test session.
7-53

Table of Contents

Related product manuals