I
-
I
-
[HARDKEY)
I
Saftkey
Reference
1
Lil-llit
Softkey
in limit menu. Displays a menu that allows you to turn visible limit
lines on or off, and to reposition and enable/disable the pass/fail indicator and
uPtEQns
text.
See “Customizing the Display” in Chapter 4 for more information.
Access Keys:
c-j
Limit
Maatu
Limit
Test
Softkey
in limit menu. Sets limit test status. When limit test is enabled,
an
OFF
“FAIL” or “PASS” notation may be displayed on the CRT. Pass/fail information
is also routed to the
LIMIT
TEST TTL
IN/OUT
connector on the rear panel of
the analyzer. The limits need not be visible (set to ON) for the limit test to be
valid.
See “Using Limit Testing” in Chapter 4 for more information.
Access Keys:
(-1
Ltikt
#gnu
Limit
TBX$
Softkey
in limit options menu. Allows you to enable or disable the PASS or
UN
off
FAIL text when limit testing is on. Does not enable or disable the
A
!
fail icon. The fail icon is enabled/disabled with the
LPmE%
Icon
01
off
softkey.
See “Customizing the Display” in Chapter 4 for more information.
Access Keys:
@ki%?7)
Lhit
Menu
Limit
Options
Lisl
M&g
Softkey
in
(-1
menu. Displays a transmission trace in terms of
transmission coefficient, displays a reflection trace in terms of reflection
coefficient, displays an aux input trace in volts (from 1
mV/div
to 20
V/div).
List
Trace
Softkey
in define hardcopy menu. Defines the hardcopy as a list of data trace
Vahss
values. Trace values for Cartesian format are in two columns: frequency and
amplitude. Trace values for polar format are in three columns: frequency,
magnitude, and phase. Trace values for Smith chart format are also in three
columns: frequency, resistance and complex impedance.
9-43
I-
To Next Page
Loading...
