I
-
I
-
k-1
I
Softkay Reference
H@Jr;t,
P&k
Softkey
in the max search menu. Moves the active marker to the next
Right
nearest peak to the right.
See “‘lb Use Marker Search Functions” in Chapter 4 for more information.
Access Keys:
(7%EEEj
Harker
Search
Mm
Se=&
Non-V01
Softkey
in the select disk menu. Selects the analyzer’s internal non-volatile
RAM
Di&
RAM as the location where information is saved, re-saved, or recalled.
See “Saving and Recalling Measurement Results” in Chapter 4 for more
information.
Access Keys: [SAVE RECALL) Select Disk
None
(C)@on
1C2,
BASIC,
on&)
Softkey
in
IBASIC
display menu. Displays the
measurement data on the full screen. (Does not show the
IRASIC
program on
the display at all.)
Noxmali~e
Softkey
in (display) and (CAL) menus. Equivalent to selecting
na;ta->hQ~m
and
Rata&em.
Corrects for frequency response errors only. The only
type of measurement “calibration” (other than detector zero) for power or
conversion loss measurements. This
softkey
is available under the (CAL) key
only when making narrowband unratioed measurements.
I
NOTE
I
This type of
“calibration”
is not interpolated: changes in frequency or the number of points invalidate
it.
See
“‘lb
Perform a Normalization Calibration” in Chapter 6 for more
information.
9-56
To Next Page
Loading...
