I
-
I
-
Smith
Sets the characteristic impedance used by the analyzer in calculating
Chart
23
measured impedance with Smith chart markers and conversion parameters.
Characteristic impedance must be set correctly before calibrating for a Smith
chart measurement. Acceptable values are 1
Q
to 1000 Q
Access Keys: (CAL]
Mar%
Cal
Softkey
Softkey
in the system
config
menu.
Displays a pop-up message with a
Auto-St@p
description of softkey sequencing and
softkeys
to enable or disable the
auto-step function.
See “Measurement Setup and Control with Fast Recall” in Chapter
‘7
for more
information.
Access Keys: (SYSTEM OPTIONS. System
Config
&war
TTL
Ccaxffg
Source
Softkey
in the
cal
check menu. One of the corrected measurement
Hatch
uncertainties that can be viewed after performing a
cal
check.
Refer to Chapter 6 for more information on using
cal
check.
Access Keys:
ICAL)
C&3
Chs&
Vfew
Cal
Ch@&
$$a~@
Softkey
in character entry menu.
Adds a blank space to a title or filename.
spa
Softkey
in
IFREQ)
menu.
Used in conjunction with Courter . Selects
the frequency span of source. When selected, it changes the frequency
annotation from start/stop to center/span.
See “Entering Measurement Parameters” in Chapter 2 for more information.
Split
Disp
Softkey
in more display menu. Toggles the display mode between split
EULL
split
(measurement channel 1 on top, measurement channel 2 on the bottom) and
full (both measurement channels on full screen).
See “Entering Measurement Parameters” in Chapter 2 for more information.
Access Keys:
(-1
Hare BispLay
9-75
To Next Page
Loading...
