HP 8712C User Manual

I
-
I
-
Using a Keyboard ..................
4-97
To Connect the Keyboard ............... 4-97
To Use the Keyboard to Edit ............
4-98
Front Panel Control Using a Keyboard ........ 4-99
Using an External VGA Monitor ........... 4-101
Customizing Color on an External Monitor ...... 4-102
Synchronizing and Positioning the Display ...... 4-104
5. Optimizing Measurements
Increasing Sweep Speed ...............
To Increase the Start Frequency ...........
To Set the Sweep Time to AUTO Mode .......
To Widen the System Bandwidth ..........
To Reduce the Amount of Averaging .........
To Reduce the Number of Measurement Points ....
To View a Single Measurement Channel .......
To Turn Off Alternate Sweep ............
To Turn Off Markers and Marker Tracking ......
To Turn Off Spur Avoidance ............
To Avoid Frequency Bandcrossings by Minimizing the
Span (HP 8714C only) .............
Increasing Network Analyzer Dynamic Range ......
To Increase the Receiver Input Power ........
To Reduce the Receiver Noise Floor .........
Reducing Trace Noise ................
To Activate Averaging for Reducing Trace Noise ...
To Change System Bandwidth for Reducing Trace Noise
To Eliminate Receiver Spurious Responses ......
Reducing Mismatch Errors ..............
Reducing Mismatch Errors in a Reflection Measurement
Reducing Mismatch Errors in a Transmission
Measurement ... .
Reducing Mismatch. Errors When’ Measuring’Bbth ...
5-3
5-3
5-4
5-4
5-5
5-5
5-6
5-7
5-7
5-8
5-9
5-10
5-10
5-11
5-13
5-13
5-14
5-14
5-17
5-17
5-18
Reflection and Transmission ........... 5-18
Compensating for Phase Shift in Measurement Setups . .
5-19
Port Extensions ..................
5-19
Electrical Delay
..................
5-20
Measuring Devices with Long Electrical Delay .....
5-21
Contents-4

HP 8712C Specifications

General

Brand	HP
Model	8712C
Category	Measuring Instruments
Language	English