329
Tunneling commands
bandwidth
Use bandwidth to set the expected bandwidth for an interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth (in kbps) is the interface maximum rate divided by 1000.
Views
Tunnel interface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth for an interface affects the link costs in OSPF, OSPFv3, and IS-IS. For
more information, see Layer 3—IP Routing Configuration Guide.
Examples
# Set the expected bandwidth for Tunnel 1 to 100 kbps.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] bandwidth 100
default
Use default to restore the default settings for a tunnel interface.
Syntax
default
Views
Tunnel interface view
Predefined user roles
network-admin
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of
the impact of this command when you use it on a live network.
To Next Page
Loading...
